STREET STOCK

GENERAL

This class is intended for trucks and Jeeps that are primarily street driven, have minimal modifications and are street legal. Engine, frame and body must be of same make.

BODY

1) Stock steel body (minimal cutting allowed only for tire clearance)
2) Wheel base must be stock for frame and body
3) Firewall cannot be cut, relocated or reshaped
4) Must retain factory floor pan
5) Flatbeds must meet tech approval
6) Must retain stock glass
7) Headlights and taillights required and must be functional
8) Front bumper required
9) Interior cannot be gutted
10) Race seats allowed

CHASSIS

1) Full uncut factory frame front to rear
2) Minimum 4 point roll cage required for open top vehicles
3) Suspension must be stock, lift kits allowed
4) No removal of leaf springs
5) Front and rear differentials, transmission and transfer case can be upgraded
6) Trans brakes not allowed
7) Fuel tank, battery and radiator must be in stock location
8) 4 wheel brakes, dual master cylinder required
9) Unaltered DOT tires only

ENGINE

1) Motor must pull 17 “ of vacuum at 800 RPM’s
2) Big block engines in full size ¾ or 1 ton trucks only
3) No V8’s in mini trucks or mini SUV’s (Unless OEM)
4) Motor must be located in stock location
5) No aluminum engine blocks or aluminum heads (Unless OEM)
6) Single gas carb limited to 4150 / 4160 (no Predators, Dominators, no splits, no stretched)
7) OEM fuel injection only
8) Cast aluminum intake only (no tunnel rams or sheet metal intakes)
9) Headers are allowed, mufflers are required and exhaust must extend to behind the drivers seat

Vehicles must meet all safety requirements.